The Official SAAC Forum
December 15, 2017, 01:16:56 AM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News:
 
   Home   Login Register Search New Photo Gallery Calendar Contact Chat  
Pages: [1]   Go Down
  Print  
Author Topic: Hole in trunk raiser , right side, '66 GT350  (Read 756 times)
0 Members and 1 Guest are viewing this topic.
kram350
Jr. Member
**
Offline Offline

Posts: 76


Email
« on: September 04, 2017, 10:40:06 AM »

There is a 1/4" hole on the right side of the raiser end panel (mirror image of the hole on the left side where the plastic wire hanger is for the fuel tank sender wire). Is this hole plugged with a grommet, tape, left open, etc...

Also, the two rubber plugs, each side of the cowl at the front fenders; painted in-place or just left as is ?

Thanks in advance. 

Logged
J_Speegle
Hero Member
*****
Offline Offline

Posts: 4974

www.ConcoursMustang.com


WWW Email
« Reply #1 on: September 04, 2017, 11:05:57 AM »

Not sure where this hole is. Picture might help

Unaware of any plastic wire holder for the fuel sender wire in the trunk on a 66 San Jose fastback except for the one wire retainer to the drivers side trap door frame panel

Could you be referring to the two larger holes (not used for the gas tank mounting in the lip (used to attach the gas tank to the forward floor sections, drivers and passenger trunk floor and the rear trunk panel)  along the front edge (others along the other panel lips. These are just left open, often sealed or partially sealed by the gas tank sealant

As for any rubber/plastic plug they were added after the car was painted

« Last Edit: September 04, 2017, 11:22:37 AM by J_Speegle » Logged

Jeff Speegle
Enthusiast, Judge, Detail Collector, ConcoursMustang.com Mentor
6S2020
Hero Member
*****
*
Offline Offline

Posts: 943


« Reply #2 on: September 04, 2017, 11:21:37 AM »

Not sure where this hole is. Picture might help

Unaware of any plastic wire holder for the fuel sender wire in the trunk on a 66 San Jose fastback

As for any rubber/plastic plug they were added after the car was painted

Think he is refering to the panel/panels beside the trap door, drivers side has plastic clip for fuel sender wire.

Logged

SFM6S2020  1 of 29 Factory Black (no LeMans stripe) non Hertz cars. SAI company car.
Better to be a Racer for a minute than a spectator for a life time.
J_Speegle
Hero Member
*****
Offline Offline

Posts: 4974

www.ConcoursMustang.com


WWW Email
« Reply #3 on: September 04, 2017, 11:28:11 AM »

Think he is refering to the panel/panels beside the trap door, drivers side has plastic clip for fuel sender wire.

Thought that hole wasn't as large as 1/4"  but maybe it is.

Was just rewritting my response and adding to it when you posted so we both caught it at the same time. Thought he was describing the panel and hole near where the wire exits the trunk.

If it is the passenger side trap door side panel then none of the unused holes would be plugged

Logged

Jeff Speegle
Enthusiast, Judge, Detail Collector, ConcoursMustang.com Mentor
kram350
Jr. Member
**
Offline Offline

Posts: 76


Email
« Reply #4 on: September 04, 2017, 12:14:17 PM »

Yes, sorry hard to describe, passenger side near trap door, hole is .195 diameter. Looks as if could be for a plastic wire holder?

Logged
J_Speegle
Hero Member
*****
Offline Offline

Posts: 4974

www.ConcoursMustang.com


WWW Email
« Reply #5 on: September 04, 2017, 01:25:10 PM »

Yes, sorry hard to describe, passenger side near trap door, hole is .195 diameter. Looks as if could be for a plastic wire holder?

Just left unused

Logged

Jeff Speegle
Enthusiast, Judge, Detail Collector, ConcoursMustang.com Mentor
kram350
Jr. Member
**
Offline Offline

Posts: 76


Email
« Reply #6 on: September 04, 2017, 08:13:11 PM »

Thanks !

Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Site Customized by DragonFly Designs StatsPowered by MySQL Powered by PHP Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC Valid XHTML 1.0! Valid CSS!