Author Topic: 1968 Shelby Fog Light part (metal mounting spacer, see photo)  (Read 1120 times)

Craner

  • Full Member
  • ***
    • View Profile
1968 Shelby Fog Light part (metal mounting spacer, see photo)
« on: August 14, 2021, 01:46:37 PM »
Searching for Lucas Type Fog Light mounting block. (Qty 1)
The photo below has this highlighted.. pointing to hardware spacer.
Any information is appreciated.
Thank you
Fran


Coralsnake

  • SAAC Member
  • Hero Member
  • *
  • The original Influencer
    • View Profile
    • theCoralsnake.com
Re: 1968 Shelby Fog Light part (metal mounting spacer, see photo)
« Reply #1 on: August 14, 2021, 02:40:51 PM »
The thick one is factory, the other one is not

Craner

  • Full Member
  • ***
    • View Profile
Re: 1968 Shelby Fog Light part (metal mounting spacer, see photo)
« Reply #2 on: August 14, 2021, 04:27:14 PM »
Ok
Thank you for setting me straight in this.
Below are photos of the fog lights that came mounted on my KR.
This is the hardware that was used.
Based on what you have said… then delete the extra metal spacer and then this would be correct, as per factory installation. 
Also included a screen shot of the Ford parts book for reference. 

Coralsnake

  • SAAC Member
  • Hero Member
  • *
  • The original Influencer
    • View Profile
    • theCoralsnake.com
Re: 1968 Shelby Fog Light part (metal mounting spacer, see photo)
« Reply #3 on: August 14, 2021, 04:52:54 PM »
The light on the bottom of your photo has the correct hardware

Bob Gaines

  • SAAC Member
  • Hero Member
  • *
  • Original Posts:14706
    • View Profile
Re: 1968 Shelby Fog Light part (metal mounting spacer, see photo)
« Reply #4 on: August 14, 2021, 05:01:22 PM »
I believe that the thinner spacer was used on regular Mustang fog lights.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

Craner

  • Full Member
  • ***
    • View Profile
Re: 1968 Shelby Fog Light part (metal mounting spacer, see photo)
« Reply #5 on: August 14, 2021, 05:08:13 PM »
Thank you!
Greatly appreciate all of the Forum Support.

CharlesTurner

  • SAAC Member
  • Hero Member
  • *
    • View Profile
Re: 1968 Shelby Fog Light part (metal mounting spacer, see photo)
« Reply #6 on: August 15, 2021, 11:01:22 PM »
I had a larger diameter regular spacer and the inner tooth style washer... should there only be the inner tooth washer?  Late April '68 Ford build, assume May Shelby build.
Charles Turner
MCA/SAAC Judge