Anybody got any pics please?? I recieved a good pic at the control valve a while back, from here. Mainly need routing from the pump and in front of the lower control arm. The new line I am using has a paralell offset from the pressure side of the pump. Since the car was in a basket when purchased, I don't know if the offset goes up or down. Up and the line goes straight for the #6 header tube... Down and it causes a very sharp 180 turn just to go back in front of and then below the motor mount/lower control arm. Also not sure if I am to route lines behind or in front of the oil filter. It is a small block car and I am not using a cooler. Help! I am having an aneurism trying to struggle thru this. Thanks.